top of page

SHARC Assortment Blade Drive Components for Hydmech Band Saws

Fits Hydmech saws with Renold / Canimex Gear Boxes calling for either of the listed cross numbers. 48mm Bore

HYD-809297

16" Drive Wheel for Hydmech Band Saws

This Lock or Connection Pin is used to attach the Idler Wheel Tension Slide to the Tension Shaft on Hydmech S20 Series III or any machine calling for the listed cross number.

HYD-007.4824

Tension Cylinder Lock Pin for Hydmech Band Saws

This Potentiometer is used on various Hydmech Saws to Adjust Blade Speed.

HYD-817704

Blade Speed Potentiometer with Knob for Hydmech Band Saws

This 16" Driven/Idler Wheel fits Smaller Hydmech Saws and is easily identified by the internal bearing of 6308. (If your bearings are 6307, you would need SHARC Part HYD-812887)

HYD-812889

Idler / Driven Wheel for Hydmech Band Saws

This Hydraulic Cylinder is utilized to tension the blade on Hydmech H-14 Saws or any other saw calling for the listed cross numbers.

HYD-803040

Blade Tension Hydraulic Cylinder for Hydmech Band Saws

This Vari Speed Belt is used on Various Hydmech Saws

HYD-340345

Vari Speed Drive Belt for Hydmech Band Saws

This Tension Slide fits Hydmech S20 Series III or any other machine calling for the listed cross numbers.

HYD-001.5208

Band Tension Slide for Hydmech Band Saws

Fits Hydmech S20, S16, H12 and any Saw using the 812887 Idler Wheel. Wheel Comes assembled with Bearings and Snap Ring.

HYD-812887

16" Idle Wheel Assembly for Hydmech Band Saws

bottom of page