top of page

SHARC Part Number:


Gear Shaft for Amada VM Series Band Saws

Please Click Image to Magnify

This is the "Gear" Shaft for the Amada VM Series Saws

Made in the USA Badge.png


Replaces Part Numbers:

11242820, 11162409, 1240277B
Due to the nature of the 90 degree gear set up in the VM Series Brush Drive,
This Shaft is not shipped with Pre-Drilled Holes for the Gear (There is one for the U Joint)
It is recommended that the unit be assembled with the gears held in place by
the Gear Set Screws, then after proper gear mesh is achieved, disassemble and
drill the shaft hole with the gear in place as a guide.
bottom of page